PC Compatibility Chart
It
is
necessary
to
set the PC correctly to display XGA and WXGA signal. Refer
to
page 14 to set PC input signals.
PC Resolution
Horizontal Frequency
Vertical Frequency VESA Standard
720 x 400
31.5 kHz
70 Hz
-
VGA
31.5 kHz
60 Hz
0
640 x 480
37.9 kHz 72 Hz
0
37.5 kHz 75 Hz 0
35.1 kHz
56 Hz
0
SVGA
800 x 600
37.9 kHz 60 Hz
0
48.1 kHz
72 Hz
0
PC
46.9 kHz 75
Hz
0
48.4 kHz
60
Hz 0
XGA
1024 x 768
56.5 kHz 70
Hz
0
60.0 kHz 75 Hz
0
WXGA
1360 x 768 47.7 kHz 60 Hz
0
SXGA 1280 x 1024
64.0 kHz 60
Hz
0
SXGA+ 1400 x 1050
64.0 kHz 60 Hz
0
UXGA 1600 x 1200
75.0 kHz 60 Hz
0
*
*
*
*
*These 4 formats are not supported by the analog RGB terminal.
DOC is a registered trademark
of
Video Electronics Standards Association.
Power Management is a registered trademark
of
Sun Microsystems, Inc.
VGA and XGA are registered trademarks
of
International Business Machines Corp.
Information on the Software License for This Product
• Software composition
The software included
in
this product
is
comprised of various software components whose individual copyrights
are held by SHARP
or
by third parties.
• Software developed by SHARP and open source software
The copyrights for the software components and various relevant documents included with this product that were
developed
or
written by SHARP are owned by SHARP and are protected by the Copyright Act, international treaties,
and other relevant laws. This product also makes use
of
freely distributed software and software components
whose copyrights are held by third parties. These include software components covered by a GNU General Public
License (hereafter GPL), a GNU Lesser General Public License (hereafter LGPL) or other license agreement.
• Obtaining source code
Some
of
the open source software licensors require the distributor to provide the source code with the executable
software components. GPL and LGPL include similar requirements. For information on obtaining the source code
for the open source software and for obtaining the GPL, LGPL, and other license agreement information, visit the
following website:
http://www.sharpusa.com/gpl
We are unable to answer any questions about the source code for the open source software. The source
code
for
the software components whose copyrights are held by SHARP
is
not distributed.
• Acknowledgements
The following open source software components are included
in
this product:
• linux kernel/busyboxluClibc/zlib/libpng/libjpeg
CLEARING THE SECRET NUMBER
If
you forget the secret number, clear the secret number using the following procedure.
1 Press
MENU
to display the MENU screen, and then press IJ,/'f to select "Parental control" and press
~
to
enter
it.
2 Press J;/'f
to
select "Change PIN" and press 0711 as a master code.
3 Enter a new PIN. (see page 21.)
The secret
number
is
[[II]
.
ImD
•
As
a precautionary measure, make a note of your secret number above, cut
it
from this manual, and keep
it
in
a safe place.
@-26