H
PC audio select
When connecting devices with HDMI cable to the
HDMI1 terminal, and inputting analogue audio signals
from the HDMI1/PC(AUDIO) terminal.
Selected item Description
HDMI1 When connecting devices with HDMI
cable to the HDMI1 terminal.
PC When connecting devices with HDMI
cable to the HDMI1 terminal, and
inputting analogue audio signals from the
HDMI1/PC(AUDIO) terminal.
• Set this to “PC” when connecting devices with HDMI cable
to the HDMI1 terminal and inputting analogue audio signals
from the HDMI1/PC(AUDIO) terminal. If “HDMI1” is set,
there will be no sound output.
• Set this to “HDMI1” when connecting devices with HDMI
cable to the HDMI1 terminal only.
Setup menu (Continued)
H
4:3 mode
The WSS signal has 4:3 auto-switching that allows you
to select between Panorama and Normal.
Selected item Description
Panorama Wide image without side bars
Normal Normal range keeping 4:3 or 16:9 aspect
ratio
WSS signal 4:3 screen
4:3 mode “Panorama” 4:3 mode “Normal”
H
Quick start
You can reduce the TV’s start-up time after turning on
the power with the remote control unit.
Selected item Description
On The TV quickly starts up from standby,
more of power consumption is required
during standby.
Off Power consumption is small during
standby.
H
Language
You can also select a language from setup menu.
Select from 3 languages: English, Traditional Chinese
and Simplified Chinese.
H
Identification
You can check the current version of the software on the
screen.
H
Reset
If complex adjustments are made and the settings
cannot be restored to normal, you can reset the
settings to the factory preset values.
To Next Page
Loading...
Need help?
General