In the NICAM TV broadcasts
When receiving a stereo signal
Each time you press MPX, the mode switches
between NICAM STEREO and MONO.
Stereo mode
When receiving a bilingual signal
Each time you press MPX, the mode switches among
NICAM CH A, NICAM CH B, NICAM CH AB and MONO.
Bilingual mode
A-TV: Press to switch to analogue TV mode. After
switching from digital TV or external input mode to
analogue TV mode, the TV jumps to the most recently
viewed analogue channel.
D-TV: Press to switch to digital TV mode. After
switching from analogue TV or external input mode
to digital TV mode, the TV jumps to the most recently
viewed digital TV channel.
When you watch the TV for the first time
When the TV powers on for the first time after
purchase, perform the auto installation.
A-TV (Analogue TV)
You can run the auto installation to set channels
automatically.
1
To watch the analogue TV, select “Auto
installation” from Setup menu. (See page 15.)
2
After setting the channels, you can select
a channel using CH
r
/
s
or 0 – 9 on the
remote control unit.
D-TV
When the TV accesses to D-TV mode for the first time,
you need to run the auto search. To scan all available
services in your area, follow the procedures below.
1
To watch D-TV broadcasts, select “DTV” from
auto installation menu. (See page 15.)
2
After setting the channels, you can select
a channel using CH r/s or 0 – 9 on the
remote control unit.
To Next Page
Loading...
Need help?
General