Entering and exiting the adjustment process mode
1. Turn off the power by pushing the “Power” key of “Touch sensor” when TV is working. Hold down “Power” key until central
“ICON” FLASHES once (5-6 sec).
2. While holding down the “VOL (-)” and “INPUT” keys on the set at once, push the “Power” key of touch sensor. Release
“Power” key when “ICON” is lighting.
Keep pushing “VOL-” and “INPUT” until backlight turns on.
3. Next, hold down the “VOL (-)” and “P ( DOWN)” keys on the set at once.
Multiple lines of blue characters appearing on the screen indicate that the set is now in the adjustment Process mode.
If you fail to enter the adjustment process mode (the display is the same as normal start-up), retry the procedure.
4. To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off the power.
(When the power is turned off with the remote controller, once unplug the AC power cord and plug it in again. In this case, wait 10 seconds or so
before plugging.)
Issued by:
CE After Sales Service
July 2011
Service Mode
To Next Page
Loading...
