106
CREATING MEMORY BOXES IN THE MACHINE FOR
F-CODE COMMUNICATION
Before the F-code communication function can be used, special memory boxes must be created using "F-Code Memory
Box" in the system settings for fax.
A box name and F-code (sub-address and passcode) are programmed in each box, and an F-code communication
function is assigned to each box.
After you have created a memory box, inform the other party of the sub-address and passcode of the box.
To use the following F-code communication functions, F-code memory boxes must be created in your machine.
F-code confidential reception, F-code polling memory, F-code relay broadcast transmission
To use the following F-code communication functions, F-code memory boxes must be created in the other machine.
F-code confidential transmission, F-code polling reception, F-code relay request transmission
System Settings for Fax: F-Code Memory Box
This is used to configure memory boxes for F-code communication.
• Up to 100 memory boxes can be created.
• The memory box name cannot be longer than 18 characters, and the sub-address and passcode cannot be longer than 20
digits.
☞ Programming an F-code Memory Box (Polling Memory) (page 149), Programming an F-code Memory Box
(Confidential) (page 151), Programming an F-code Memory Box (Relay Broadcast) (page 154)
• Memory box name
• Sub-address
• Passcode
• End receiving machines (only in an F-code relay
broadcast memory box)
• Print PIN (only for F-code confidential reception)
Memory box for F-code
communication
To Next Page
Loading...
