29
REPLACING SUPPLIES AND MAINTENANCE
Replacing the staple cartridge in the finisher
When the staple cartridge runs out of staples, a message will appear in the
operation panel. Follow the procedure below to replace the staple cartridge.
1
Open the cover.
2
While pressing the lever over to the left, slide the
finisher to the left until it stops.
Gently slide the finisher until it stops
3
Lower the staple case release lever and remove
the staple case.
Pull the staple case out to the right.
mxb401_us_saf.book 29 ページ ２００９年１月７日 水曜日 午後３時３３分
To Next Page
Loading...
