Sharp MX-M260 - Setup in a Macintosh Environment; Mac os X

29
29
ENGLISH
This chapter explains how to install the PPD file to enable printing from a Macintosh and how to
configure the printer driver settings.
☞MAC OS X: this page
(v10.2.8, v10.3.9, v10.4.11, v10.5 - 10.5.6)
☞MAC OS 9.0 - 9.2.2: page 35
MAC OS X
1
Insert the "Software CD-ROM"
into your computer's CD-ROM
drive.
Insert the "Software CD-ROM" that shows
"Disc 2" on the front of the CD-ROM.
2
Double-click the [CD-ROM] icon
( ) on the desktop.
3
Double-click the [MacOSX]
folder.
Before installing the software, be sure to read
"ReadMe First". "ReadMe First" is in the
[US-English] folder ([English] folder in areas
other than the U.S.) in the [Readme] folder.
4
Double-click the folder
corresponding to the versions of
the operating system.
5
Double-click the [MX-B08] icon
().
• The PS3 expansion kit is required to use the machine as a printer in a Macintosh environment. In
addition, the machine must be connected to a network. A USB connection cannot be used.
• The PC-Fax driver cannot be used in a Macintosh environment.
• The explanations of screens and procedures are primarily for Mac OS X v10.4. The screens may
vary in other versions of the operating system.
• Make sure that AppleTalk is activated before installing the PPD file.
Note
If the "Authenticate" window appears
in Mac OS X v10.2.8, enter the
password and click the [OK] button.
v10.3.9
v10.5 -
10.5.6
v10.4.11
v10.2.8
Note
SETUP IN A MACINTOSH ENVIRONMENT
Setup_multi.book 29 ページ ２００９年７月７日 火曜日 午後２時８分