39
WHEN INSTALLATION WAS NOT SUCCESSFUL
The machine is not 
detected (when 
connected to a 
network).
Is the IP address of the 
machine configured?
If the IP address of the machine is not 
configured, the machine will not be detected. 
Make sure that the IP address is configured 
correctly in "Network Settings" in the machine's 
administrator settings.
Is your computer connected to 
the same network as the 
machine?
Windows:
If the machine and your computer are not 
connected to the same local area network, the 
machine will not be detected. If the two are 
connected to different sub-networks, click the 
[Specify condition] button and enter the 
machine's name (host name) or IP address to 
search for the machine.
Macintosh:
If multiple AppleTalk zones exist, select the 
zone to which the machine is connected from 
the menu.
The machine is not 
detected (when 
connected to a 
network).
Is the machine power on? If the machine is powered off, it will not be 
detected. (In Windows, search again after 
powering on the machine.)
Is your computer connected 
correctly to the machine?
Make sure that the cable is connected securely 
to the LAN connectors on your computer and 
the machine.
Check the connections at the hub as well.
☞ CONNECTING TO A NETWORK  (page 6)
The plug and play 
screen does not 
appear (USB 
connection in 
Windows).
Can your computer use a USB 
connection?
Check your computer whether or not a USB 
interface can be used on the Device Manager 
in your computer. (For information on "Device 
Manager", see Help in Windows.)
If USB can be used, your controller chipset type 
and root hub will appear in "Universal Serial 
Bus controllers" in "Device Manager". (The 
items that appear will vary depending on your 
computer.)
If these two items appear, USB should be 
useable. If a yellow exclamation point appears 
next to "Universal Serial Bus controllers" or the 
two items do not appear, refer to your computer 
manual or check with the manufacturer of your 
computer to enable USB and then reinstall the 
printer driver.
Problem Point to check Solution
Setup_multi.book  39 ページ  2009年7月7日 火曜日 午後2時8分