Sharp PN-L702B - Other Functions; Cautionary Points; Eraser

20
E
Press-and-tap
Sameactionasright-clickingamouse.
Withonengertouchingthescreen,taponce(singletap)with
anothernger.
Withonengertouching
Taponce(singletap)withanothernger
TIPS
• Thescreenmaynotrespondcorrectlyinthefollowing
cases:
Touchingistooquick
The distance between the two points is too short
The two points intersect
• Operationwiththetouchpenisnotpossible.
n
Pen actions
Pen tip
Function Button 2
Function Button 1
Ultrasonic transmitter
Battery indicator
Function Button 1
PressingFunctionButton1hasthesameactionasright-
clicking a mouse.
The battery indicator illuminates.
Function Button 2
InthePenSoftware,pressingFunctionButton2hasthe
action that is set in the Pen Software.
The battery indicator illuminates.
TIPS
• UseFunctionButton1andFunctionButton2nearthefront
of the screen. If too far away, operation will not be possible.
• PressFunctionButton1andFunctionButton2slowly
andrmly.Ifpressedtooquickly,theactionwillnotbe
recognized.
• Ifthepentipbecomeswornordamaged,replaceit.Pull
out the old pen tip and insert a new pen tip.
Other functions
InWindows7,touchpointerandinputpanelfunctionscanbe
used.
Forinformationonthesefunctions,seeWindowsHelp.
Touch pointer :
A translucent image of a mouse appears near the point
touched. The left/right buttons of the image can be clicked
to perform the same actions as left/right clicking a mouse.
Input panel :
A software keyboard and an input panel with handwriting
recognition appear on the screen.
InWindows7(excludingStarter),theinkfunctionofMicrosoft
Ofcecanbeused.
Handwritten comments can be written, and handwriting can
berecognized.
Fordetails, see MicrosoftOfceHelp.
Cautionary points
• Donotusethetouchpenforanypurposeotherthantouch
panel operation.
• Donotpresshardonthepentip.
•
Do not cover the ultrasonic transmitter of the touch pen with
yourhandornger.
• Operation will not take place correctly if there is an obstacle
between the infrared transmitter/receiver and the touch pen
oryournger.Operationwillnottakeplacecorrectlyifyour
ngers or your sleeve is near the screen.
• Ifthetouchpenisheldtooatagainstthescreen,the
touch position may not be correctly detected.
• Ifthetouchpendoesnotworkattheedgeofthescreen,
move it slowly.
• Donotstorewiththepentipofthetouchpenorfunction
button pressed. The battery will be exhausted.
• Donotusenearadevicethatemitsultrasonicwaves.The
touch pen uses ultrasonic waves and may not operate
correctly.
• Iftwotouchpanelsareusedincloseproximitytoeach
other, use handwriting mode. The touch pens will interfere
with each other and will not operate correctly.
• Ifthereisdirtorforeignmatteronthetipofthetouchpen,
removeit.Foreignmattermaydamagethescreen.
• Applicationssuchasascreensaverormediaplayermay
causetheresolutiontoautomaticallychange.If"Resolution
ChangeNotice"isenabledinthetouchpaneldriver,a
resolution change message will appear. In this case,
disable"ResolutionChangeNotice",orchangethesetting
in the application so that it does not change the resolution.
• Thepenmaybeoutofpositionintheloginscreen.Inthis
case, use the keyboard or mouse.
• IftheUSBcablebecomesdisconnected,thetouchpanel
may not operate correctly after the cable is reconnected. In
this case, restart your computer.
Eraser
TheeraserisusedwiththePenSoftware.Fortheprocedure
for using the eraser, refer to the Pen Software Operation
Manual.
Caution
• Whenusingtheeraser,gentlybringtheclothsideinto
contact with the screen. Touching the screen with one of
thenon-clothsideswilldamagethescreen.
• Ifthereisanydirtorforeignmatteronthesurfacethat
contactsthescreen,removeit.Foreignmattermaydamage
the screen.
Touch Pen Preparations/Touch Action