3-3
3.1.2 Space requirement
For safety reason, Path must be considered when installing. For space, it requires:
Its calculation is the area of the arm rotating 360 de
ree, the most outer circle and plus 1000
mm. Different models has different dimensions.
MODEL The distance from the
column center to the arm
limit.
Plus maintenance area
(A)
Total space
requirement
(B)
TPR-1230 1546 mm 1000 mm 5092 mm
TPR-1230H 1546 mm 1000 mm 5092 mm
TPR-1600H 2087 mm 1000 mm 6174 mm
TPR-2000H 2537 mm 1000 mm 7074 mm
3.2 Environment requirement
a. Never put the machine in the places where sun shines directly on it.
b.
Temperature: normal range is between +5
℃ and
40
℃
.
c.
Humidity: between 30% and 95%. At the max. temperature 40
℃，The relative
humidity should not be over 50％. And at the relative lower temperature, higher
humidity is acceptable I.g. at temperature 20℃,
humidity 90％ is fine.
d. Please keep the machine away from gasoline, chemical substances, dust, acid, sulfides,
magnetic interference and explosive environment.
e. Please keep the machine away from the electrical interference source like welding
machine and EDM.
f. The installation ground must be flat.
g. The illumination of the work area: greater than 500lux.
h. Good ventilation.
i. Please take care there is no hydraulic splash to prevent from anyone slipping tripping
and falling in danger.
j Please take litter to the Recycling Center or any appropriate equipment.
To Next Page
Loading...