6-4
6.4 Adjust tighten the clamping device
After the machine has been used a period of time, the tighten the clamping device. It is the
time to adjust its tightness clamping device of adjusting nut.
6.4.1(For TPR-1230, TPR-1230H)
Fig a-1 Fig a-2 Fig b Fig c.
The relevant
names
The relevant names
No. Name No. Name
1. Release switch 3. Adjusting nut
2. Clamping switch 4. Fastening nut
Adjust tighten the clamping device lever as follows:
a. Press the button marked 1 in the below figure. Release the button only after you turn the
arrowhead to the point B, referring to the figure b. After the button released, the claming device
an be released.
b. Release the fastening nuts marked 3 in the figure 3.
c. Turn the adjusting bolts about 180° clockwise, using a spanner.
d. Tighten the fastening nuts marked 3 in the figure c.
e. Press the button marked 2 in the below figure a. Release the button only after you turn the
arrowhead to the point A, referring to the figure b. After the button released, the claming
device can be tightened.
To Next Page
Loading...