Sharp RD-1600 - Change Oil Inside of the Speed Reduction of the Arm Elevating Motor

7-3
7.2.5 Change oil inside of the speed reduction of the arm elevating motor.
It requires only one person to do it. Please press down the emergent stop button and power off
before proceeding the job.
（For TPR-1230, TPR-1230H）
A. Instruction to the
relevant parts.
B. The following is the tools
to replace the oil.
1.
Oil filler points Oil (CC68) 2 L
2.
Oil gauge
Container and spanner.
3.
Drain outlet
The steps:
1. Power off.
2. Press down the emergent stop button.
3. Place the container under the drain outlet.
4. Release the drain plug using a spanner.
5. After draining, tape the plug with a sheet of band and tighten it back to the drain
outlet.
6. Release the oil filler plug.
7. Add oil to the upper limit of the oil gauge.
8. Tighten the oil filler plug.
（For TPR-1600H/ TPR-2000H）
Instruction to the relevant parts.
No. Parts
1. Oil filler points
2. Oil gauge
3. Drain outlet
The following is the tools to replace the oil.
Oil (CC68)1 L
Container and spanner.
The steps:
1. Power off.
2. Press down the emergent stop button.
3. Place the container under the drain outlet.
4. Release the drain plug using a spanner.
5. After draining, tape the plug with a sheet of band and tighten it back to the drain outlet.
6. Release the oil filler plug.
7. Add oil to the upper limit of the oil gauge.
8. Tighten the oil filler plug.