7-6
7.3 Replace the cutting fluids.
It requires only one person to do it. Please power off and press down the emergent stop
power button before carrying out the job.
A. Instruction to the relevant parts.
1. Oil filler points
2. Oil drain outlet
B. The following is the tools to replace the cutting
fluids.
The cutting fluids 30L
Container and spanner
The steps：
1. Power off.
2. Press down the emergent stop button.
3. Place a container under the oil drain outlet.
4. Release the drain plug using a spanner.
5. After draining, tape the plug with a sheet of band and tighten it back to the drain outlet.
6. Refill the cutting fluids through the oil filler inlet to the level under 5 mm under the oil filter.
7.4
Maintenance and replacement period.
No. Position Items. Period
1. Oil filler points of the column CC68 once per day.
2. Oil filler points on top of the gearbox CC68 once per day.
3. Oil filler points in the right side of the gearbox. CC68 once per day.
4. Oil filler points in the left side of the gearbox. CC68 once per day.
5. Oil filler points of the spindle XM2 once per day.
6 Replace oil for the speed reduction of the arm
elevating motor.
CC68 once per year.
7 Change oil inside of the gearbox. CC68 once per year.
8 Chang the cutting fluids. The cutting fluids Once per month
9 The arm transmit ion ball screw XM2 Once per week
10. Replace the hydraulic oil CB32 once per year.
A suitable Oil Type comparison:
ISO DIS-3498
SHELL MOBIL ESSO CHINA
CB32 TELLUS C32 DTE OLL LIGHT TERESSO 32 R32
CC68 OMALA 68 MOBILGEAR 620 SPARTAN EP68 HD68
XM2 ALVANIA R2 MOBILUX 2 BEACON 2 #2
7.5 Waste disposition.
Please proceed waste disposition such as machine oil, iron filings, old machine or replaced
parts according to your country’s relevant legal regulation.
To Next Page
Loading...