Sharp RD-1600 - For TPR-1600 H, TPR-2000 H; Rotate the Arm Forward or Backwards; For TPR-1230,TPR-1230 H)

5-16
5.10 Rotate the arm forward or backwards.
5.10.1 (For TPR-1230,TPR-1230H)
1. Press the figure1 shown in the bottom left. Referring to the up right picture, release the
button after pointing the arrow head to B. The clamping device is released now.
2.
Push the arm moving lever backwards to move the arm backwards, as shown in figure 3. Pull the
arm
moving lever towards to move the arm towards, as shown in figure 3.
3.
Press the figure2 shown in the bottom left. Referring to the up right picture, release the button
after pointing the arrowhead to A. The clamping device is tightened now.
Precaution：
After UNLOCK pressed, the Arm can move for and backwards in addition to move left and
right wards. If 180 degree rotation is needed, the ground needs to be processed according the
method in the chapter 3, where the base bolts are required and need to be fastened by nuts.
5.10.2（FOR TPR-1600H, TPR-2000H）
1. Press the figure1 shown in the bottom left. Referring to the up right picture, release the
button after pointing the arrow head to B. The clamping device is released now.
2.
Push the arm moving lever backwards to move the arm backwards, as shown in figure 3.
Pull the arm moving lever towards to move the arm towards, as shown in figure 3.
3.
Press the figure2 shown in the bottom left. Referring to the up right picture, release the
button after pointing the arrowhead to A. The clamping device is tightened now.
Precaution：
After UNLOCK pressed, the Arm can move for and backwards in addition to move
left and right wards. If 180 degree rotation is needed, the ground needs to be
processed according the method in the chapter 3, where the base bolts are required
and need to be fastened by nuts.