6-2
6.2.2(For TPR-1600H/ TPR-2000H)
Fig. a. Fig. b. Fig. c.
The relevant names The relevant names
No. name No. name
1. Release switch
3.
Adjusting nut
2. Clamping switch
4.
Fastening nut
Adjust the arm clamping lever as follows:
a. Press the figure1 shown in the bottom. Referring to the up right picture, release the
button after pointing the arrow head to b. The clamping device is released now.
b. Release the fastening nuts, totally 5 pieces, in the figure c and mark 4.
c. Using a wrench, adjust the nuts counter clockwise about 180°. (totally 5 pieces bolts)
d. Fasten the nuts, marked 4 in the figure c. (totally 5 pieces bolts)
e. Press the figure2 shown in the bottom left picture 1. Referring to the up right picture,
release the button after pointing the arrowhead to A. The clamping device is tightened
now.
To Next Page
Loading...