15
MAKING COPIES
I
I
I
I
I
I
I
I
COPYING FROM THE DOCUMENT GLASS
Use the document glass for copying single originals, bound
documents, and other originals that cannot be set on the RADF.
●
2-sided to 2-sided or 2-sided to 1-sided cannot be selected when
copying from the document glass. These operations, however,
can be performed by manually turning over the originals.
1-sided copies of 1-sided originals
Open the RADF cover and place an original face down
on the document glass, using the centring scale to
position it.
Close the RADF cover.
Ensure that 1-sided to 1-sided is selected on the
ORIGINAL TO COPY section of the operation panel.
Use the TRAY SELECT key to select the desired paper
tray.
Use the 10-key pad to enter the desired number of
copies.
●
The number will be shown on the COPIES SELECTED
display.
●
Use the CLEAR/STOP key to cancel an entry if a mistake is
made.
Press the START key.
●
The number in the COPIES MADE display will increase by 1
each time a copy is made.
Copying from the document glass
2
1
3
4
5
6
START
4
78
0 /
AUDIT
CLEAR
12
3
5
6
2.
3. A3
1.
B4
TRAY SELECT
A4
1
2
3
2
1
1
1
1
ORIGINALS
)
(
EVEN NUMBER
ORIGINAL TO COPY
2
2
1
1
PRE-COUNT
ORIGINAL
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
