Sharp SD-2060 - SPECIAL PAPERS (Manual Feed)

19
MAKING COPIES
I
I
I
I
I
I
I
I
SPECIAL PAPERS (manual feed)
The bypass tray is used to copy onto transparency film, labels,
tracing paper, and other special purpose papers. It is also used to
feed cover stock and insert stock. Up to 100 sheets of standard copy
paper can be set on the bypass tray.
Set the original(s) face down in the RADF tray or on the
document glass.
Unfold the bypass tray extension.
●
Be sure to unfold the bypass tray extension when feeding large
size paper such as A4R, B4 and A3 (8-1/2" x 11"R, 8-1/2" x 14"
and 11" x 17") size paper.
Set the bypass tray guides to the width of the copy
paper.
Insert the copy paper all the way into the bypass tray.
●
Labels, tracing paper, and special purpose papers other than
SHARP standard transparency film must be fed individually.
●
Up to 100 sheets of standard copy paper measuring from A5 to
A3 (8-1/2" x 5-1/2" to 11" x 17") can be loaded into the bypass
tray.
●
A5 (8-1/2" x 5-1/2") size paper must be set according to width.
●
When adding paper, first remove remaining paper, combine it
with the paper to be added and then reload as a single stack.
Set the number of copies.
●
Use the TRAY SELECT key to select the bypass tray.
Press the START key.
1
2
3
4
Special papers (manual feed)
START
4
78
0 /
AUDIT
CLEAR
12
3
5
6
Bypass tray extension
5
6
Downloaded from: http://www.usersmanualguide.com/