77
I
I
I
I
OPTIONAL EQUIPMENT
I
I
I
I
Staple cartridge replacement
The message “ADD STAPLES. FOLLOW INSTRUCTIONS INSIDE
THE SORTER.” will appear when the staple cartridge is empty. Re-
place the staple cartridge as follows:
Open the stapler cover.
Pull the empty staple cartridge up and out to remove it.
●
Do not remove the staple cartridge unless the message “ADD
STAPLES.” is displayed. Doing so will cause the stapler to
jam.
Remove the protective covering from a new staple
cartridge and check to ensure the staples are all
stacked within the cartridge.
●
No staple sheet should be protruding into the staple guide. If
one is, push it back into the staple cartridge.
●
The cartridge holds 5000 staples.
Insert the new staple cartridge into the stapler until it
clicks into place.
Close the stapler cover.
Place a sheet of paper into the bin below the non-sort
bin. Press the manual staple key when it lights up.
●
Check to ensure that the sheet is stapled.
If it is not stapled, press the manual staple key again.
●
If the stapler does not operate properly even after replace-
ment, a staple may be jammed in it. See the next page.
●
Staples for the staple sorter are available from your Sharp
dealer.
20-BIN STAPLE SORTER(SF-S53)
6
1
2
3
4
5
Protector
20-bin staple sorter(SF-S53)
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
