I
COPIER
TROUBLE?
65
I
I
I
I
I
I
I
Problem Solution
●
Copier plugged in? Plug the copier into a grounded
outlet.
Copier does not operate.
●
Power switch on? Turn the power switch on.
●
Power up timer mode is set. Turn the power switch off, then
on again.
Copies are too dark or too light.
●
Copy density properly adjusted? See page 20.
Blank copies.
●
Is the original placed face Place the original face down.
down?
●
Paper too heavy? Use copy paper within the speci-
fied range. See page 48.
Copies smear if rubbed.
●
Paper damp? Replace with dry copy paper. Be
sure to store copy paper in a dry
location.
TROUBLESHOOTING
●
Always check the message display whenever the copier stops or
operation is not possible. The messages will give you easy-to-
follow directions. If the messages do not give specific instruc-
tions, check the list below.
Trouble shooting
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
