Sharp SD-2060 - Page 31

29
MAKING COPIES
I
I
I
I
I
I
I
I
INSERTS
Enter the number of originals using the 10-key pad and
then press the PROGRAM key. If the number of
originals is not known, press only the PROGRAM key.
●
If only the PROGRAM key is pressed, the number of originals
will be counted. When counting is completed, replace the
originals in the RADF tray.
●
The message “PRINT ON THE CHAPTER PAGES? USE 10-
KEY PAD TO SELECT. YES: PUSH 1 NO: PUSH 2” will
appear.
Press key 1 on the 10-key pad to select YES.
●
The following message will appear.
PLEASE DESIGNATE ORIGINAL POSITIONS
WHICH ARE TO BE CHAPTER PAGES.
ENTRY SEQUENCE : 10-KEY
//
//
/ P KEY.
TO END SEQUENCE : PRESS P KEY AGAIN.
TO CORRECT SEQUENCE: PRESS
aa
aa
a KEY.
OUTPUT
SAMPLE
PLEASE INPUT PAGE NUMBERS.
P
●
The P in the display corresponds to the position of the first
original to be copied onto an insert sheet. In this example, this
is position 3.
Use the 10-key pad to designate the position of the first
original to be copied onto an insert sheet and then
press the PROGRAM key. In this example, press key 3
and then the PROGRAM key.
●
The entered number will be displayed on the bottom line of the
message display.
Inserts
5
4
78
AUDIT
CLEAR
12
3
5
6
0 /
PROGRAM
CLEAR ALL
P
CA
6
4
78
9
AUDIT
CLEAR
12
3
5
6
CLEAR/STOP
0 / C /
7
4
78
AUDIT
CLEAR
12
3
5
6
0 /
PROGRAM
CLEAR ALL
P
CA
4
1
5
7
2
3
6
<M092>
Downloaded from: http://www.usersmanualguide.com/