Sharp SD-2060 - Page 48

46
MAKING COPIES
I
I
I
I
I
I
I
I
JOB MEMORY
Deleting a stored job program
Follow steps 1 and 2 in “Storing a job program.” (1.
Press the PROGRAM key. 2. Press the 0 key.)
Press key 2 on the 10-key pad.
●
The following message will appear.
TO DELETE A PROGRAM FROM THE STORAGE
REGISTER : PRESS 1 TO 9 KEY AND START
KEY.
Enter the storage register number of the program to be
deleted.
Press the START key.
●
The program will be deleted from memory.
Recalling a job program
Press the PROGRAM key.
●
The following message will appear.
RECALL FROM: 1,2,3,4,5,6,7,8,9
TO STORE OR DELETE PROGRAMS PRESS 0.
●
The numbers which appear in the display are storage registers
which contain stored programs.
Use the 10-key pad to select a stored program from 1 to
9.
●
The copier will show all selections stored in the program.
●
The recalled settings may be modified for a particular job run,
but any changes made will not be stored in the job memory. To
store the new settings, follow the “Storing a job program”
procedure.
1
<P005>
3
4
1
<P001>
2
Job memory
4
78
9
AUDIT
CLEAR
12
3
5
6
CLEAR/STOP
0 / C /
4
78
9
AUDIT
CLEAR
12
3
5
6
CLEAR/STOP
0 / C /
ERA
CHAN
START
9
C /
3
6
CLEAR/STOP
4
78
9
AUDIT
CLEAR
12
3
5
6
CLEAR/STOP
0 / C /
INFORMATION
PROGRAM
CLEAR ALL
P
CA
4
1
2
Downloaded from: http://www.usersmanualguide.com/