Sharp SF-2022 - Page 12

ee dAINOL/MAdvd
Jeuo} Bulppy
ES ot rN» )s) Nem re), =15
The indicator will light when toner is
needed. If copying is continued, the indicator
will begin blinking, and the Copier will stop.
The toner required indicator may also begin
blinking during long copy runs of multiple dark
originals even though toner is left. If the
indicator begins to blink, the Copier will stop
making copies. Open and close the front
cover. When sufficient toner has been fed,
the toner required indicator will go out and
the READY indicator will light green. Press
the print button to resume copying.
NOTE:
If copying is continued while the(s3,) indicator is lighted,
copies will gradually become lighter until the copier stops
and the indicator blinks.
6
] Open the front cover.
Tap on the side of the toner cartridge several times
before removing it.
While pressing down on the lever, carefully pull the
cartridge until it stops, then tilt it upward slightly and
continue to pull to remove it.
© Take a replacement cartridge from its box and use the box
for disposal of the old cartridge.
Shake the new toner cartridge four or five times and
install the new toner cartridge.
While holding the toner cartridge, pull out the toner
sealing tape completely.
Ciose the front cover.