Service and Maintenance Manual 3-96 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
PRINTHEAD CRADLE ASSEMBLY
PRINTHEAD PRESSURE CAMS (con’t)
4. Remove the top shoulder bolt from the gas
spring on the right side of the machine. Be
sure to catch the four nylon washers that are
between the plate and the spring.
5. Remove the eight screws identified in Figure 3-
238. This will allow the right side cradle plate
to rotate on the back flanged bushing. Gently
slide the plate away from the machine, and turn
the plate towards the rear so it is out of the
way. This will also allow the roller identified to
be removed.
6. Remove the E-Clip from the printhead pivot
shaft.
7. Remove the five screws identified in Figure 3-
240. This will allow the right inner plate to be
removed.
Figure 3-237. Removing the Gas Spring
Figure 3-238. Screw Identification for Right Side Plate
Figure 3-239. Removing the E-Clip
Figure 3-240. Screw Identification for Right
Inner Plate.
To Next Page
Loading...
