Service and Maintenance Manual 3-129 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
SEALPOINT COMPONENTS
Seal wires, Teflon tape, and anvil rubber are
available together in the Sealer Maintenance Kit
(P/N 960552-01), which is available from Sharp
Packaging Systems Inc. These wear items are
inexpensive and easy to replace, yet provide great
improvement to the overall quality of the seals
when replaced at regular intervals.
Seal Wire
If the Sharp SX
TM
will not seal bags, remove the
Teflon tape to expose the seal wire. If the seal wire
is not broken, further troubleshooting is required
(See the Electrical Assembly: Transformers
section to troubleshoot the seal wire circuitry).
The seal wire is adjustment free.
1. Remove the front lexan guard (Figure 3-328).
2. Completely remove the Teflon tape from the
seal wire area (Figure 3-329).
Always remove electrical power from the
SX
prior to performing any maintenance
Figure 3-329. Removing the Teflon Tape
Figure 3-328. Guard Identification
To Next Page
Loading...
