Service and Maintenance Manual 3-60 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
PHOTOELECTRIC SENSOR (con’t)
14. Follow the cable through the machine and wire
tie it to the cable bundle.
15. Reinstall all guards removed in step 1, and
close the cradle cover.
FILM FEED MOTOR DRIVE BELT
1. Ensure the film feed motor drive belt has the
proper tension. Refer to Machine
Adjustments: Checking Belt Tension section
to determine the correct tension.
2. Perform a visual inspection of the belt. If it is
showing signs of wear, such as cracking or
fraying, it needs to be replaced.
Refer to the Machine Adjustments: Checking
Belt Tension section.
Perform the following steps to replace the film feed
drive motor belt.
1. Remove the outside frame guard and the front
load plate (Figure 3-151).
2. Loosen the four motor mounting screws. The
head of the screws can be accessed through
the opening exposed by removing the load
plate (Figure 3-152).
3. Once loosened, slide the motor up to create
slack in the belt. Remove the belt from the
motor pulley and release the motor. The belt
can then be removed from the machine and
replaced.
Always remove electrical power from the
SX
prior to performing any maintenance
Figure 3-152. File Feed Drive Motor Mounting
Figure 3-151. Guard Identification
Frame
To Next Page
Loading...
