Sharp SX 1075

OPERATION
SX™
Service and Maintenance Manual
A-6
960714-02B © 2007 I2407
SX TABLETOP BAGGER
PRINTER MENU STRUCTURE
FIRMWARE VERSION SHARP.ZS
MENU MODE
(Press the menu button to enter MENU MODE)
MEDIA SETTINGS PRINT CONTROL PRINTER OPTIONS SYSTEM SETTINGS COMMUNICATIONS DIAGNOSTICS
MEDIA TYPE SENSOR TYPE LABEL LENGTH MAXIMUM LABEL LENGTH PAPER OUT DISTANCE LABEL WIDTH SENSOR CALIBRATION
DIRECT THERMAL
* THERMAL TRANSFER
* CONTINUOUS
REFLECTIVE
0-99.99 0-99.99 0-99.99 0-6.62
PERFORM CALIBRATION
ADVANCED ENTRY
HEAT PRINT SPEED FEED SPEED REVERSE SPEED ROW OFFSET
COLUMN OFFSET PRESENT DISTANCE
2-6 0-99.99
CUSTOM ADJUSTMENTS
DARKNESS ROW ADJUST COLUMN ADJUST
PRESET ADJUST
0-30 2-8
2-10 0-99.99 0-4.00
1-64 0-128 0-128 0-128
MODULES PRESENT SENSOR CUTTER GPIO PORT
ENABLE
* DISABLE
PRINT FILE FORMAT MODULE DELETE FILE PACK MODULE
PRINT DIRECTORY
ALL
D
G
Y
FRANCAIS
ITALIANO
DEUTSCH
ESPANOL
D RAM
G FLASH
Y PROTECTED
D RAM
G FLASH
Y PROTECTED
SERIAL PORT A SERIAL PORT B PARALLEL PORT A PARALLEL PORT B NIC ADAPTER HOST SETTINGS
BAUD RATE PROTOCOL PARITY DATA BITS STOP BITS
7-8 1-21200 BPS
2400 BPS
4800 BPS
9600 BPS
19200 BPS
28800 BPS
38400 BPS
BOTH
SOFTWARE
HARDWARE
NONE
NONE
ODD
EVEN
PORT DIRECTION PORT STATUS
UNI-DIRECTIONAL
BI-DIRECTIONAL
ENABLE
DISABLE
HOST TIMEOUT CONTROL CODES FEEDBACK CHARACTERS ESC SEQUENCES HEAT COMMAND
STANDARD CODES
ALTERNATE CODES
ALTERNATE CODES 2
ALTERNATE CODES 3
SPEED COMMANDS
1-60 ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
HEX DUMP MODE OPTIONS TESTING PRINT TEST RATE (MIN) SENSOR READINGS RIBBON SENSOR LIMITS
0-120
TEST CUTTER MONITOR GPIO INPUT TEST GPIO OUTPUTTEST PRESENT SENSOR
LABEL PRESENTED
ENABLE
DISABLE
PERFORM TEST
1 TIME
10 TIMES
100 TIMES
GPIO END OF PRINT
* ACTIVE HIGH
ACTIVE LOW
* ENABLE
DISABLE
PULSED HIGH
PULSED LOW
* 15 * 5.5
DENOTES OPTIONS AVAILABLE
* DENOTES DEFAULT SETTING
KEY
Figure A-1. SX
TM
Printer Menu Flowchart