Service and Maintenance Manual 3-128 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
STRIPPER PLATE ASSEMBLY (con’t)
18. Reinstall the film feed take-up shaft and the
platen roller take-up shaft (if equipped with a
printer) (Figure 3-326).
19. Reinstall the film feed motor drive belt. Apply
downward pressure on the motor to tension the
belt. At proper tension, the belt should deflect
about 3/32” at the center of belt span using one
finger to push the belt. When proper tension is
achieved, tighten the four motor mounting
screws (Figure 3-327).
20. Reinstall all guards removed in step 1 above.
Take-Up Shaft
Take-Up Shaft
(Optional)
Figure 3-326. Film Feed Belt Take-Up Shaft
Figure 3-327. File Feed Drive Motor Mounting
To Next Page
Loading...
