Service and Maintenance Manual 3-134 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
SEAL WIRE TENSION SPRINGS (con’t)
7. Lift the heater block back into position, and
reinstall the eight mounting screws (Figure 3-
340).
8. Reinstall the seal wire changing tools to
compress the tension springs, and reinstall the
seal wire. Be sure the orientation is such that
the open ends of the seal wire are to the
bottom of the machine (Figure 3-341).
9. Remove the adhesive backing from a new strip
of Teflon tape, and place over the seal wire,
ensuring it is completely covering the wire.
10. Reinstall the front guard.
Figure 3-340. Heater Block Mounting Screws
Note: Viewed from Rear; Cradle Removed for Clarity
Figure 3-341. Seal Wire Mounting Screws
To Next Page
Loading...
