Service and Maintenance Manual 3-144 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
SECTION 3 – COMPONENT REPAIR
JAW POSITION SENSORS (con’t)
5. Route the new sensor cable through the
machine, following the path taken by the old
cable. Be sure to secure the cable to existing
wire bundles or frame members to keep clear
of moving parts.
6. Follow the steps outlined in the “Adjustments”
section on page 3-141 to secure the sensor(s)
in place.
7. Replace any guards removed in the previous
steps.
To Next Page
Loading...
