Figure 3-36. 24 VDC Power Supply
24 VDC POWER SUPPLY (con’t)
7. Reconnect all wires to the Power Supply
(Figure 3-36).
8. Place new Power Supply in the Sharp SX
TM
Bagger in the same location and orientation as
the old power supply.
9. Use screws from old Power Supply and secure
new Power Supply to the frame.
10. Reconnect power cord to the Sharp SX
TM
Bagger and turn machine on.
11. Set your DVOM to a range capable of
measuring 24 VDC.
Service and Maintenance Manual 3-14 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
To Next Page
Loading...
