LINE FILTER (con’t)
There are no adjustments necessary on the Line
Filter.
1. Remove the six screws holding the Frame
Cover, set screws and Frame Cover aside
(Figure 3-45).
2. Remove the seven screws holding the Mandrel
Support Plate, set screws and plate aside
(Figure 3-46 & 3-47).
Note: There are seven screws holding the
Mandrel Support Plate. Use care when
removing bottom screws and never work on an
unstable platform.
3. Remove the three spade connectors from the
Line Filter (Figure 3-48).
Figure 3-45. Frame Cover Screws
Figure 3-48. Remove three spade connectors
Support
Figure 3-46. Mandrel Support screws
Figure 3-47. Mandrel Support Plate Bottom
Screws
Always remove electrical power from the
SX
prior to performing any maintenance
Service and Maintenance Manual 3-18 960714-02B © 2007 I2407
SECTION 3 – COMPONENT REPAIR
To Next Page
Loading...
