Sharp UP-600

CHAPTER 12. IN-LINE CABLE
1) Remove the rear cover.
2) Connect the LAN cable
to the LAN connector .
3) Install the core
to the LAN cable .
NOTE: Install the ferrite core in a position less than 50mm from the
cabinet.
CHAPTER 13. RS232 DEVICES
NOTE: Install the ferrite core in a position less than 10mm from the
RS232 connector.
For the RS232 Relay PWB, the signals can be switched over
according to the device to be connected.
a) D-SUB connector
With the switch: S401, the signal to Pin 9 can be switched over
between +5 and CI.
b) Modular RJ45 connector
With the switches: S403/S404, the signal to Pin 4 can be
switched over between CD, CI, VCC (+5V) and GND.
Do not change the default positions unless instructed to.
1
2
3
IN-LINE cable
Cabinet
Within 50mm
Core
Moduler RJ45 connector
D-SUB connector
Cable
Core
Wire band
RS232 connector
Within 10mm
CI
S401
+5V
S403 S404
CI CD
VSC GND