Sharp VC-H705X

Q Setting the Channels _
Your VCR can receive VHF channels 0 to 12, and UHF channels 28 to 69. Your VCR has 48 programmable
channel positions, each of which can be set to any of the above broadcast channels. The channel positions
have been preset at the factory as shown below.
[note >
• Use the A / ▼ / ◄ / ► buttons on the remote control to set
the OSD.
• Channel position numbers 0, 1, 3 to 6, 8, 11 to 27, and 29
to 47 have been factory set to be skipped when
CHANNEL A or T (CH A or ▼ ) is used.
• If the picture is not clear, if you want a different channel
from the one preset or if you wish to reset a skipped
channel, reset the channel as follows.
Position
Preset TV Channel
Position
Preset TV Channel
0
Skipped channel
8
Skipped channel
1
Skipped channel
9
VHF 9
2
VHF 2
10
VHF 10
3
Skipped channel
11*27
Skipped channels
4
Skipped channel
28
UHF 28
5
Skipped channel
29-46
Skipped channels
6
Skipped channel
7
VHF 7
47
Skipped channel
AUTO TUNING
PREPARATION
•Select the video channel on your TV and turn on the VCR.
MENU
o*
MENU
TIMER
MODE
CLOCK
LANGUAGE
A ▼ : S ELE C T
SET:ENTER MENU:EXIT
▲ SET
T*0
O Press MENU
Select item “CFIANNEL PRESET" with A/T and press
SET
▲
or
T
CHANNEL PRESET_
MANUAL
A ▼ • S E LECT
SET;ENTER MENU:EXIT
_— _
. SET
1 o
© Select item “AUTO" with A/T and press SET.
1
AUTOMATIC TUNING.
PLEASE WAIT.
MENU:EXIT
i Normal
^ Screen
© The channel display on the TV screen will continue
through all of the channels and when finished, the TV
screen will return to the normal screen.
The bar display indicates the estimated amount of
channels tuned.
---
nNOTE~>
• If additional unwanted channels were found, refer to page 15 to skip unwanted channels.
• If some channels were unable to be found, refer to Manual Tuning on page 14.
13