Sharp VC-H705X

re VCR Display _
When DISPLAY is pressed, the display changes in the following way, (However, the following is the case when
the clock time is set and displayed in the 12-hour system.)
During Playback
Example:
[TAPE COUNTER]
QnmnH
Example:
[TAPE REMAINING]
120 ►
0
i *f
' r
SP h
L • _
J 0
Example:
[PRESENT TIME]
—»
During Recording
Example: Example: Example:
[COUN TER] [REMAINING TIME] [PRESENTTIME1
I NOTE >
• During Simple Recording Timer recording or Recording with the Timer, “a" lights.
—>
Example:
[CHANNEL MODE]
Counter Clear
Make sure the counter is displayed, then press CLEAR on the remote control. “0:00 00”
is displayed.
1 NOTE >
• The counter will reset to “0:00.00” when the tape is rewinded completely.
1 [22]
n • n
n n n
SP
u • u LI • IJ U
Tape Speed Selection
This VCR contains 3 tape speeds.
SP (Standard Play) : Gives the best picture quality.
LP (Long Play) : Gives the double recording time.
EP (Extended Play) : Gives the triple recording time.
During Recording
•When the input signal is PAL signal, each time the TAPE SPEED is pressed, tape speed change as below:
SP-> LP -> EP
•When the input signal is SECAM/MESECAM signal, each time the TAPE SPEED is pressed tape speed
change as below: ’ ^ H
SP-» LP
•When the input signal is NTSC signal, each time the TAPE SPEED is pressed, tape speed change as below:
SP-» EP
[NOlO
'[EjrtendeTpiaylTodef PAL EP (Extended Play) mode can only be P | a y b a ck in a VCR with the same function (PAL EP
• For best result, it is advisable to playback or recording EP mode with this VCR.