Sharp VC-H705X

Simple Recording Timer
There are two ways to use this Simple Recording Timer for I • Immediate recording-
your convenience I. ~ . . y *
Immediate Recording
S.PICTURE ON
Convenient when having an unexpected visitor or
telephone call.
• Delayed recording:
Convenient when leaving the house or going to bed.
O Select the channel position to be recorded bv oressina
CHANNEL A/T. y
(Ex.: Channel position: 2)
| S.PICTURE ON
B STEREO
SP STOP 11:3 OMJ L R
8 : 0 0 A M REM 2:00
15/12 00 0:00.00
® Press REC to enter the normal recording mode. Then,
press REC repeatedly to set the desired ending time
(Ex.: Ending time: 11:30 AM)
[NOTE >
• Each press of REC increases the stop time by 10 minutes.
• Press STOP to terminate recording.
Delayed Recording
© T.
CHANNEL s
©
CHANNEL s. picture on
Select the channel position to be recorded bv oressino
CHANNEL A/T
(Ex.: Channel position: 2)
0 TIME " 2
V-L:, S. PICTURE ON^
t I ©START Cg ; 4 OiV-STEREO
© Set the starting time by pressing 0TIME
(Ex.: Starting time: 8:40 AM)
I NOTE >
• Each press of 0 TIME increases the start time by 10 minutes.
• Setting the time within a 24-hour period in 10-minute intervals
is possible.
REC S.PICTURE ON
©START 8:4 OAK STEREO
\-/ SP STOP —9 :3 Oil— L R
© Set the ending time by pressing REC.
(Ex.: Ending time: 9:30 AM)
I NOTE >
• Each press of REC increases the stop time by 10 minutes.
6STANDBY
© Press STANDBY to turn off the power.
(Ex.: Present time: 8:28 AM)
*fste C Ji h g e e3T) 0rdin9 ^ TAPE SPEED ° n the rem ° t6 COntro1 ' “ SP ' ' " E P " or " L p " W" light up on the VCR display.
•After the Simple Recording Timer is set, the channel position cannot be chanqed
power! 6 6ndinS time ' tUm ° n thC P0W6r ' Th6n pr6SS STIME t0 confirm the startin 9 and
' dea! e a a fteTse S Sa e trrn C m d thP IlT s®*" 9 S* 9 ° f “ D e l ayed Recordin 9”. press CLEAR on the remote control. To
time is fSshing, press^ CLEAR. Pr6SS ° t0 Se ‘ e Ct Simple Recordin 9 Timer ™ d ® . and then while the 0 START
The Simple Recording Timer cannot be set if the timer has been preset (“0 ” indicator on the VCR disnlav is litl If this ic the
S^pie C Recordhig t T m l er. tandl:>y ^ ™ E R ° N /0FF '
‘ ISin t0P time f ° r de ' a yed recording must be set within 10 seconds of setting the start time, otherwise start time must be set
24