Sharp VC-H705X

Tape Remaining Display
The tape remaining only works with tapes recorded in PAL. It does not work with tapes recorded in NTSC
On Screen Display
•Select FULL or
COUNTER display mode
by pressing MODE OSD
on the remote control.
REK 1:05
0 : 0 0 . 0 0
VCR Display
• Press DISPLAY on the remote
control.
I NOTE >
»« ■ — * <« *»*"« ««
‘ gS b * Tte W “" 9
[OSD]
u
[VCR display]
•Setting the-DPSS or ZERO BACK function during computation may JnceHt W lnterrupt ® com P u tation '
•The indicated length of tape remaining is only an approximate guide.
• ThP lLTnth°nf tl ay n0t properl ^ w ork for video ta P e s other than E-60, E-90, E-180 and E-240
• When and faS * fo ™ ard ° r reWind may be indicated as 9 r eater than « actually is.
When IVHSM and bLVHSIH tapes are used with a cassette adapter, the indication may not be correct
Warning for the length of tape remaining
When the tape reaches the point where only about five minutes of
tape will be automatically displayed, as a warning.
recording time is left, the
remaining length of
I NOTE >
• No warning, however, will be shown during timer recording or Simple Recording Timer recording.
32