Sharp VC-H705X

Recording with the Timer
The timer can be set manually for automatic recording of up to 8 events over a 365 day period.
PREPARATION
•Select the video channel on your TV. Turn on the VCR.
• Load the cassette, ensuring the erasure protection hole is covered. The VCR power will automatically turn on.
• Check that the clock is displaying the correct time. (See Setting the Clock on page 12.)
PROCEDURE
Example: Recording channel position 47 in SP mode from 12:00 PM to 12:30 PM, December 15 2000 if the
present time is 10:28 (morning), December 14, 2000.
nmcn
O*
[Timer position]
O Press TIMER.
Select the timer position with a/T and press SET.
• If the timer positions 1 to 4 have already been set, the
screen changes 2/2 (timer positions 5 to 8).
Numeric
buttons
or
A/T
DATE PR START STOP
© Set the date for timer recording with the numeric buttons
or A/T on the remote control and then press ► .
• First set the “day” digits and then “month”, if there is
only one “day” or one “month” digit, enter a 0 first.
[Once]
* ►
A [Daily/Weekly]
* A/T * ►
If you want to record only once, press ► and go to step
©. Otherwise, select "D (DAILY)” to record at the same
time each day or “W (WEEKLY)” to record at the same
time each week by pressing A or ▼ and then pressing
[Channel]
Numeric
buttons
DATE PR START STOP
15/12 EE " :
Set the channel number using the numeric buttons or
A/T and then press ► .
1 NOTE >
• To record audio and video from an external source through an
AUDIO/VIDEO terminal on the VCR, press a/T to select an
AV channel. (When an AV position is selected, “LI” or “L2” is
displayed where a channel position number is usually
displayed.)
Continued on next page
1 A/ ▼ can also be used to set the date and time instead of the numeric buttons.
1 Press 0 first if the day, month, hour or minute is a single digit.