Sharp VC-H705X

Recording with the Timer
Numeric
buttons
or
A/T
When the clock is set
to 24H mode, "AM/
PM” will not appear.
1/2
j DATE PR START) S T O P
15/12 47 BCTBTB8 — SP
► ►
© Set the start time with the numeric buttons or a!W and
press ► .
[Stop]
Numeric
buttons
or
A/T
Set the stop time with the numeric buttons or ±/T and
press ► .
DATE PR START STOP
15/12 47 12:0 OPhL
► ►
[Tape Speed]
DATE PR START STOP
15/12 47 12 : 00PX12 : 3 Qprfj
A
or
T
i NOTE ">
• SP: Standard Play
• LP: Long Play
• EP: Extended Play
© Select the tape speed with A or Y. (See Intelligent
Timer Recording (JUST REC) on page 29.)
I NOTE '>
• If the COLOUR mode is set to “AUTO", when a SECAM signal
is received and the EP mode is selected, the VCR will
automatically change the EP mode to LP mode.
• A tape recorded in the PAL EP (Extended Play) mode can only
be playback in a VCR with the same function (PAL EP
[Extended Play] mode).
• For best result, it is advisable to playback or recordina EP
mode with this VCR.
[Timer review]
SET
o
1/2
DATE PR START STOP
15/12 47 12:00M12:30WSP
▼ ▼ 2/2 ▼ ▼
CLEAR:CANCEL
A ▼ ; S E L ECT
SET:ENTER MEND:EXIT
© Press SET. To programme additional timer settinqs
repeat steps © through ©.
MENU
o *
Normal
Screen
To return to the normal screen, press MENU.
TIMER
CD *
To set the VCR for automatic timer recording, press
TIMER ON/OFF and ensure the “0” indicator lights on
the VCR display.
I NOTE '>
* (ffee^page 3®°)°^® Spe ® d with TAPE SPEED 0n the remote contro1 ' “ SP ”. “E p ” or "L p ” will light up on the VCR display.
’Ltomatfcally 038861 * 6 ° Ut reCOrdin9 a " the P r o 9 r ammes, your VCR will stop, eject the cassette, and shut off
* If twer nN/ftPP Pted f ° r m °J e t han P minutes (power failure ’ etc - ) ' a " t jmer settin 9 s will be cancelled
no ™ s s i°e ^ iS n ° CaSS6tte l0aded ' ' ,G] " f lashes for 5 seconds, indicating that timer recording is
* cassette* isejected.' S PreSS6d WhHe ® CaSS6tte With an uncovered erasure protection hole is loaded, “0” flashes and the
*^Ctar'vCR end setting/cancelling/confirming timer positions are not possible. For
the timer (“0" disappear^ and then turn'^o'nJoufvCR ,ng/COnf,rming timer positions ' P r ess ™ E R ON/OFF to disengage
* During timer recording, the timer cannot be set.
* To terminate timer recording, press STOP during timer recording.
* It the same time is input for the start time and the stop time, the timer setting will be cancelled.
26