Sharp VC-H705X

Recording a TV Programme
Cassette Erase Protection
A ®4® cassette has a removable tab to prevent accidental erasure of recorded
material. Removing the tab prevents recording. To record on a video cassette with the
tab removed, place adhesive tape over the tab opening.
Recording a TV Programme
EF
PF
^ASURE
^OTECTION TAB
yfi
mi M)\
s
iiu_yj)
CHANNEL
a/t
PAUSE/STILL
PREPARATION
•Turn on your TV and select the video channel.
PROCEDURE
O Turn on the VCR.
© Insert the cassette, making sure the erasure protection hole is covered.
© Select the channel position you wish to record with CHANNEL Air (CH a/T)-
© Select the SP (Standard Play), EP (Extended Play) or LP (Long Play) recording speed with TAPE SPEED on
the remote control (“SP”, “EP” or “LP" will light up on the VCR display). SP (Standard Play) gives the best
picture quality, EP (Extended Play) gives the triple recording time and LP (Long Play) gives the double
recording time.
I NOTE >
• If the COLOUR mode is set to “AUTO”, when a SECAM signal is received and the EP mode is selected, the VCR will
automatically change the EP mode to LP mode.
• VC-H705X is not equipped with the NTSC tuner. If you want to record the NTSC signal with this VCR, connect this VCR to the
other equipment with the NTSC tuner. (See NTSC AV Recording on page 23 )
© Press REC. (If the erasure protection hole is uncovered, the cassette will be ejected.) To pause during
recording, press PAUSE/STILL (F. ADV). To resume recording, press PAUSE/STILL (F, ADV) again.
© To stop recording, press STOP.
Tnote >
• The pause mode disengages automatically after about 5 minutes, and the VCR enters stop mode.
• To record audio and video from an external source through the AUDIOA/IDEO terminal on the front or rear of the VCR, press
INPUT SELECT on the remote control or press CHANNEL A/T (CH A/T) to select the LI or L2 channel position situated
between the last channel and first channel. (When the LI or L2 position is selected, "LI" or “L2” is displayed where a
channel position number is usually displayed.)
• if the TV signals are weak and the picture changes to monochrome, set the PAL mode on the MODE selection screen. (See
Colour Mode on page 18.) Normally, the colour mode should be set to “AUTO”.
To Watch Another TV Programme While Recording
After steps Q to © have been completed, select the programme you wish to view using the TV tuner. At the
end of the tape, your VCR will automatically stop recording, rewind to the beginning of the tape, eject the tape
and turn off the power.
21