Sharp XE-A207W - Removing the Receipt Paper Roll; Removing the Paper Jam

126

■
Removingthereceiptpaperroll
When colored dye appears on the edges of the paper roll, it is time to replace the paper roll. Use paper of
57.5 ± 0.5 mm in width. To prevent jamming be sure to use paper specied by SHARP.
1.
Conrm that the REG mode has been selected.
2.
Remove the printer cover.
3.
Lift up the print roller arm.
4.
Remove the remaining paper roll from the paper roll cradle.
5.
Install a new paper roll correctly by following the steps in “Installing the Paper Roll.”
Print roller arm

■
RemovingthePaperJam
Caution:Thepapercutterismountedontheprintercover.Becarefulnottocutyourself.Never
touchtheprinterheadimmediatelyafterprinting,astheheadmaystillbehot.
1.
Remove the printer cover.
2.
Lift up the print roller arm.
3.
Remove the paper jam. Check for and remove any shreds of paper that may remain in the printer.
4.
Reset the paper roll correctly by following the steps in “Installing the Paper Roll.”
Print roller arm