15
(4.4.4) Save
Use this menu to save your loops:
1. When you first open the Save menu, the save slot will be highlighted. Turn the encoder to select an
EMPTY save slot. There are 128 available slots in Sheeran Looper +’s internal storage.
If you navigated away from the save slot and need to reselect it, turn the encoder until it is
highlighted, and then push to select it.
2. When you have selected an empty save slot, push the encoder to confirm.
3. The SAVE option will become highlighted after a save slot is chosen. Push the encoder again to
save the loop to the selected slot.
If you wish to cancel, turn the encoder so that CANCEL is highlighted, then push to confirm.
Alternatively, do nothing until you are returned to the main screen.
Note: If no loop is recorded, this option will be greyed out.
(4.4.5) Load
Use this menu to load previously saved loops:
1. When you first open the Load menu, the saved loop slots will be highlighted. Turn the encoder to
select an available saved loop.
If you navigated away from the saved loop slots and need to reselect them, turn the encoder until
it is highlighted, and then push to select it.
2. When you have selected a saved loop, push the encoder to confirm.
3. The LOAD option will become highlighted after a save slot is chosen. Push the encoder again to
load the loop.
If you wish to cancel, turn the encoder so that CANCEL is highlighted, then push to confirm.
Alternatively, do nothing until you are returned to the main screen.
(4.4.6) Delete
Use this menu to delete previously saved loops:
1. When you first open the Delete menu, the saved loop slots will be highlighted. Turn the encoder to
select an available saved loop.
If you navigated away from the saved loop slots and need to reselect them, turn the encoder until
it is highlighted, and then push to select it.
2. When you have selected a saved loop, push the encoder to confirm.
3. The DELETE option will become highlighted after a save slot is chosen. Push the encoder.
4. A second confirmation screen will appear. To proceed, push the encoder again while YES is
highlighted. The selected loop will be deleted. This action cannot be undone.
If you wish to cancel, turn the encoder so that CANCEL is highlighted, then push to confirm.
Alternatively, do nothing until you are returned to the main screen.
To Next Page
Loading...
