17
(4.4.10) MIDI
This menu determines the MIDI functionality of Sheeran Looper +. Turn the encoder to select the
following menus, and then push it to view the available options:
• Source: Determines the MIDI input source. Select Off to disable MIDI input, 1/8” to use the MIDI
In jack on the rear panel, or USB to use the USB port on the rear panel.
• Channel: Determines the MIDI channel that Sheeran Looper + will receive MIDI data on (Omni
[all channels], 1–16).
• Clock: Determines whether MIDI clock is On or Off.
• Ext Ctrl: Determines whether External MIDI Control is On or Off.
See (4.5.4) Other Functions > MIDI Control to learn more about MIDI Clock and External Control.
(4.4.11) Output
This menu determines how the audio outputs are configured.
Select Mono to sum both the loop audio output and dry audio input to a mono signal sent to the L
(Mono) (left) and R (right) outputs. Select Stereo to send the loop audio output and dry audio input to
both L (Mono) and R outputs as a stereo signal. Select Split to send the loop audio output to the L
(Mono) output and the dry audio input to the R output.
(4.4.12) USB
You can connect Sheeran Looper + to your computer using a standard USB cable (not included)
connected from the USB port on the rear panel to transfer loop files.
1. While connected to a computer, navigate to this entry in the menu, and push the encoder to select
“START”. The screen will briefly show “SETUP” as it connects to your computer.
2. Once you are connected, Sheeran Looper + will appear as a removable mass-storage device called
LOOPER. Inside this drive you will find folders for the 128 available loop slots, with any available
recorded audio inside each folder.
3. WARNING: When you are finished transferring contents, you must unmount/eject the LOOPER
drive from your computer. File corruption may occur if the drive is not properly ejected before
continuing. After unmounting, push the encoder again while EXIT and RESTART is highlighted on
the display. Sheeran Looper + will restart and return to normal operation.
Important:
Do not disconnect or power off Sheeran Looper + during the process.
Any unsupported files will be ignored.
You cannot transfer a folder or .zip/archive folder to/from Sheeran Looper +. Instead, transfer any
supported files directly.
(4.4.13) About
This screen shows information about the Sheeran Looper + hardware and firmware.
To Next Page
Loading...
