Sheeran Looper + - Menu Screen Functions

14
(4.4) Menu Screen
To access the menu screen, press and hold the encoder. Turn the encoder to
scroll through the available options, and then press it again to open the menu
or make a selection.
To exit the menu, scroll the encoder to the left until it reaches the back arrow
in the top-left corner of the screen, then push the encoder. Alternatively, wait
about 4 seconds, and Sheeran Looper + will automatically return to the main
screen.
(4.4.1) Fade
Use this menu to apply a Fade In or Fade Out to the selected track. When a
track is stopped, you can apply a Fade In. When a track is playing you can
apply a Fade Out.
Use the encoder to navigate to the second page of the menu to access the
Fade length. Push the encoder to begin editing, and then turn it to set the fade
length. When you are finished, push the encoder again to apply the Fade at
the set length on the currently selected track.
Note: If no loop is recorded, this option will be greyed out.
(4.4.2) Reverse
Use this menu to set the playback direction of the loop on the currently
selected track. Use the encoder to select Normal or Reverse, and then push
to confirm.
(4.4.3) Speed
Use this menu to set the playback speed of the currently selected track. Use
the encoder to select Normal or 1/2 Speed, and then push to confirm.