18
(4.5) Other Functions
(4.5.1) Energy Save Mode
If you are operating Sheeran Looper + on battery power, after two minutes
of inactivity (not playing back or overdubbing), the display will dim, and an
“Energy Save Mode” screen will appear. Press any pedal or use the encoder
to dismiss the screen and return to normal operation.
(4.5.2) Low Battery Warning
If you are operating Sheeran Looper + on battery power, two warnings will appear as your
batteries drain to let you know it is time to recharge or connect to power.
When there is 25% battery life remaining, the battery icon in the lower-right corner of the
display will turn yellow, and the display will be reduced to 50% brightness.
When there is 10% battery life remaining, the battery icon in the lower-right corner of the
display will turn red. Save your loop and connect to power as soon as possible.
(4.5.3) Memory Full Warning
Sheeran Looper + includes internal storage space for over three hours of
looping. If you fill up the entire storage, a warning will appear on the display
to indicate that saving has been disabled. You will need to Delete loops or
transfer them off Sheeran Looper + using the USB connection to free up
space. Once this is done, the warning will be removed, and you can
continue recording and saving loops.
To Next Page
Loading...
