3
(1.0) Introduction
Welcome to your Sheeran Looper +!
This is a comprehensive guide designed for you to get the most out of Looper +. We recommend you
read through this guide before playing.
(1.1) Box Contents
Sheeran Looper +
(4) AA Batteries
1/8”-to-MIDI Adapter
Quickstart Guide
Safety & Warranty Manual
(1.2) Support
For the latest information about this product (documentation, technical specifications, system
requirements, compatibility information, etc.) and product registration, visit sheeranloopers.com.
For additional product support, visit sheeranloopers.com/support.
(2.0) Setting Up Your Rig
1. Position Sheeran Looper + on a flat surface, and away from any liquid hazards.
2. Make sure your output device (like a PA or guitar amplifier) is switched off.
3. Connect a microphone to the Mic input on the rear panel, and an instrument to the INST inputs. If
you are only using one instrument input, use the one labeled L (Mono).
4. Connect your output device to the Main Out. If you are only using one output, use the one labeled
L (Mono).
5. Connect your Sheeran Looper + to power. You can use the included four AA batteries inserted into
the bottom panel battery compartment, or a 9 V, 0.5 A, center-positive power adapter (not included)
connected to a power outlet.
Note: A USB cable connected from the USB port to your computer will also power Sheeran Looper +,
but this should only be used for file transfer modes.
6. Power on Sheeran Looper +.
7. Power on your output device.
8. You’re now ready to begin looping!
For a complete description of all the features of Sheeran Looper +, proceed to the following (3.0)
Features chapter.
For a walkthrough of basic looping techniques, proceed to the following (4.2) Basic Looping chapter.
When you are finished using Sheeran Looper + and ready to shut it down, power off your output device
first, and then power off Sheeran Looper +.
To Next Page
Loading...
