21
(4.5.5) Factory Reset
If for any reason you need to reset Sheeran Looper + and erase all user content, you can perform a
factory reset.
Press and hold the right STOP footswitch and encoder at the same time, and while still holding both,
power on Sheeran Looper +.
A screen will appear to warn you that resetting will erase all user content. Push the encoder to proceed.
A second screen will appear for confirmation. Turn the encoder to select YES, then push it to continue.
If you wish to cancel, turn the encoder to select NO and Sheeran Looper + will restart and power on in
normal operation.
If you select YES, the factory reset will begin, and Sheeran Looper + will restart once it has finished. All
user content will be erased, and this action cannot be undone.
To Next Page
Loading...
