16
(4.4.7) Logic
Use the encoder to set the recording behavior of the RECORD + PLAY pedal. Select R>D>P to Record,
then Overdub, then Play; or select R>P>D to Record, then Play, then Overdub.
(4.4.8) Mode
Use the encoder to select the looper mode. All track layers must be cleared to switch modes.
• Single: A single track that can be overdubbed.
• Multi: Dual looper tracks locked to the same length.
• Sync: Dual looper tracks. One track sets the length, and the other track must be a multiple or
division of that length.
• Song: Dual looper tracks that record and play back independently.
See (4.3) Operation > Looper Modes for more information on each mode.
(4.4.9) Assign
Use this menu to set the behavior of the encoder push function and external footswitches. Sheeran
Looper + supports dual function footswitches using a TRS cable to access both FS1 and FS2 options.
Turn the encoder to select ENCODER PUSH, FS1, or FS2, and then push the encoder to access the
following assignment options:
• Track: Switch between Tracks A and B.
• Solo Current: Solo the current track (while muting the other track).
• Solo A: Solo Track A (while muting Track B).
• Solo B: Solo Track B (while muting Track A).
• R/P/D B: Cycle between recording, playback, and overdubbing of Track B.
• Speed: Cycle between 1/2 Speed and Normal speed for the currently selected track.
• Reverse: Cycle between reverse audio and normal audio for the currently selected track.
• Fade All: Apply a fade in or fade out to both tracks at the same time.
• Clear: Clear the currently selected track.
• Clear All: Clear both tracks at the same time.
• Undo/Redo: Undo (temporarily clear) audio recorded since the last overdubbing began, then redo
(bring back) that audio.
• Mute Current: Mute the currently selected track.
• Mute A: Mute Track A.
• Mute B: Mute Track B.
To select an assignment, push the encoder.
To Next Page
Loading...
