12 - POWER STEERING
218
Tighten the end cap retainer bolts, 1, in the number
sequence shown in figure in two stages. First, torque the
bolts to about 1 N-m (0.1 kgf･m) and then to 17 N-m
(1.7 kgf･m), following the number sequence shown in
the figure. When done, check to make sure that the
spool turns freely in the motor and that there is no
binding.
5) Installation
1. Install the steering control valve securely with the
three retaining bolts, Turn the steering wheel back
and forth to check for freedom of movement. The
spool should turn freely in the valve.
2. Install the tubing adapters, 2, in the control valve
and tighten to 44.1 – 53.9 N･m (4.5 – 5.5 kgf･m).
3. Connect the pressure tube, 2, return tube, 3, left
turn tube, 4, and right turn tube, 5, to the control
valve, 1, and tighten to 29.4 – 39.2 N･m (3 – 4
kgf･m) securely.
42
43
44
To Next Page
