Shimaden SRS4 - User Manual


Request
The instruction manual should be kept in a handy place where the end user can refer to it when necessary.
Preface
This instruction manual (detailed version) was written for those who perform wiring, installation, operation, and routine
maintenance for the SRS0 (SRS1/SRS3/SRS4/SRS5) Series.
This manual contains a description of the operating method, functions, wiring, mounting method, and precautions
when handling the SRS0 (SRS1/SRS3/SRS4/SRS5) Series (hereinafter referred to as the SRS0 Series unless a separate
description is required). You should, therefore, keep it handy to refer to it when operating and handling the device.
Be sure to observe all precautions and adhere to the procedures provided herein.
MSRS0-E01-A
Oct. 2018
SRS0 Series
(SRS1/SRS3/SRS4/SRS5)
Digital Controller
Instruction Manual (Detailed Version)
Thank you for purchasing a Shimaden product. After making sure the product fits the desired
description, you should carefully read the instruction manual and get a good understanding of
the contents before attempting to operate the device.

Shimaden SRS4 Specifications

General

Control Method	PID control
Display	LED display
Size	1/16 DIN
Input Type	Thermocouple, RTD
Output Type	Relay, Voltage pulse, Current
Power Supply	100 to 240 VAC, 50/60 Hz
Operating Temperature	0 to 50°C
Dimensions	48 x 48 x 78 mm
Accuracy	±0.3% FS

Summary

Safety Rules and Precautions

General Safety Warnings

Critical warnings regarding personal injury, death, and electric shock hazards.

Electrical Safety Precautions

Guidelines on preventing electric shock during wiring and operation.

Equipment Protection Measures

Procedures for protecting equipment from damage and fire hazards.

Introduction and Preliminary Checks

Installation and Wiring

Wiring Instructions

Operation Preparations

Parameter Diagram and Setting

Display and Screen Navigation

Parameter Setting Details

Data Modification and Auto Return

Screen Group 0 Settings

Controller Operation Modes

Auto Tuning (AT) Execution and Cancellation

Procedures for executing, cancelling, and conditions for auto tuning.

Reset (RST) and Run (RUN) Modes

Managing controller execution states between reset and run modes.

Event and Multi SV Configuration

Event Type and Value Settings

Configuration of event types, alarm actions, and associated values.

Multi SV and External Selection

Screen Explanation and Setting Items

Fixed Value Control and PID Setting Screens

Program Setting Screens

Event and DI Settings

Explanation of Functions - Events

Alarm Actions

Details on deviation, absolute value alarms, and their triggers.

Standby and Non-Standby Actions

Event Selection Alarm Action Diagrams

Explanation of Functions - PID and Control Output

PID Control Parameters (P, I, D, MR, SF)

Explanation of Proportional, Integral, Derivative, Manual Reset, and Target Value functions.

Control Output Settings

Output Limiters and Proportional Cycle

Setting output limits and understanding proportional cycle time correlation.

Control Output Characteristics and Two-Position Action

Configuration of heating/cooling actions and hysteresis for stable output.

External Control Input (DI) Functions

Decimal Point and Start SV Settings

Decimal Point Position Adjustment

Start SV Management for Program Control

Guarantee Soak (GUA) Function

Troubleshooting and Error Resolution

Causes and Remedies for Common Troubles

Identifies common operational issues and their solutions.

Abnormal Measured Input Error Diagnosis

Guides on interpreting screen displays indicating input errors and their causes.

Specifications - Display and Input

Specifications - Control, Events, and External Input

Control Output and Event Output Specifications

External Control Input and Program Specifications