Shimaden SRS13A - User Manual

Request
The instruction manual should be kept in a handy place where the end user can refer to it when necessary.
Preface
This instruction manual (detailed version) was written for those who perform wiring, installation, and routine
maintenance for the SRS10A (SRS11A/SRS12A/SRS13A/SRS14A) Series.
This manual contains a description of the operating method, functions, wiring, mounting method, and precautions
when handling the SRS10A (SRS11A/SRS12A/SRS13A/SRS14A) Series (hereinafter referred to as the SRS10A
Series unless a separate description is required). You should, therefore, keep it handy to refer to it when operating
and handling the equipment.
Be sure to observe all precautions and adhere to the procedures provided herein.
SRS10AF-1ME
Apr. 2021
SRS10A Series
(SRS11A / SRS12A / SRS13A / SRS14A)
Digital Controller
Instruction Manual (Detailed Version)
Thank you for purchasing a Shimaden Digital Controller. After making sure the product fits the desired description,
you should carefully read the instructions and get a good understanding of the contents before attempting to operate
the equipment.

Shimaden SRS13A Specifications

General

Brand	Shimaden
Model	SRS13A
Category	Controller
Language	English

Summary

Safety Rules

WARNING

Critical safety instructions regarding potential injury or death if instructions are not followed.

CAUTION

Safety instructions regarding potential equipment damage if instructions are not followed.

Installation and Wiring

Installation Site (Environmental Conditions)

Mounting

Wiring

Detailed instructions and precautions for connecting wires to the controller terminals.

Terminal Layout

Terminal Arrangement Table

Operation Preparations

Steps to perform before operating the controller, including wiring checks and power-on.

Parameter Diagram and Setting

Parameter Diagram

Visual overview of the controller's parameter screen structure and navigation.

Screen Group 0 Settings

Setting Target Set Values (SV)

Manual Setting of Control Output

Auto Tuning (AT)

Function for automatic adjustment of PID control parameters.

Standby (STBY); Execution (EXE)

Event Setting

Configuration of alarm and event functions, including types and values.

Screen Explanation and Setting Items

PID Setting

Detailed configuration of PID control parameters for optimal performance.

Event Settings

Detailed configuration for event types, hysteresis, standby actions, and latching.

Heater Break;Loop Alarm Settings

Configuration for detecting and alarming on heater break or loop conditions.

Analog Output Settings

External Control Input DI Settings

Configuration for external digital inputs, including mode and allocation.

Communication Settings

Configuration of communication parameters like mode, speed, and protocol.

Measuring Range Codes Setting

Explanation of Functions

Events

Detailed explanation of event types, alarm actions, and standby selections.

Heater Break;Loop Alarm

Detailed explanation of heater break and loop alarm functionality.

P.I.D.

Explanation of Proportional, Integral, and Derivative control parameters.

MR (Manual Reset)

SF (Target Value Function)

Control Output

Details on output limiters, cycling time, characteristics, and two-position action.

External Control Input (DI)

Explanation of external digital inputs and their control functions.

Soft Start

Function to gradually increase control output to prevent excessive initial current.

Causes and Remedy of Trouble and Errors

Causes and Remedy of Trouble

Causes and Remedy of Errors

Parameter Mask;Lock Function

Mask;Lock Setting Contents